Production Printing
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Canon Pro-4100 -- Prints are Grainy/Noisy

Hi - I'm running into an issue I am unable to solve with grainy/noisy prints off of a relatively new Canon Pro-4100. The printer is approximately 6 months old and in good health. Prints are made on Moab Juniper Baryta Rag 305gsm paper and using a var...

signal-2023-07-13-142312_002.jpeg signal-2023-07-13-142312_003.jpeg
ams1unm by Apprentice
  • 1495 Views
  • 3 replies
  • 0 likes

PRO-4000 - yellow discolouration on print edge

Recently our Canon PRO-4000S has started leaving a band of yellow discolouration (approx 5cm wide) to the lead edge of the print. It only occurs when the printer has been idle for a period of time, ie. first thing in the morning, or after a break. It...

Skit by Apprentice
  • 980 Views
  • 1 replies
  • 0 likes

Resolved! Ink stains on my prints using my new Prograf pro 4100

I have a Prograf Pro-4100 that drops ink on everything I print, right now I am printing on Hahnemuhle Cézanne Canvas Matte, base weight: 430 gsm and thickness: 20.5 mils. This started to happen after printing about seven 34 x 44" photographs, I clean...

Canon Pro 4100 will not power on.

I was printing a job a few days ago on the canon pro 4100 all of a sudden the printer turned off during the job and will not power back on. I think it may be the power supply? any input/ advice to resetting or fixing this issue would be greatly appre...

imagerunner advance DX diagonally fed sensor

Every day, I have to scan in checks at my office, which're varying sizes. With my office's old printer, you could load them up, and they'd scan. Now, I'm getting "Originals may have been fed diagonally. Check the following:" Then it gives the option ...

wallace3 by Apprentice
  • 746 Views
  • 1 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements