How to Get the Most from Canon’s Software Tools for its Professional Inkjet Photo Printers Getting a print to match what you see on screen isn’t magic - it’s a process. And a big part of that process happens in the software. Whether you’re using the...
For the last month my new PRO-1100 is producing ink spots on one out of three prints, usually in the margins at the beginning of the print's run (see photos). I print on cotton rag fine art paper up to 17"x25" via the manual (back) feed. This problem...
I just purchased a canon prograf PRO-310 and the documentation says this has a standard size, but non-replaceable button cell battery. Seems to be a cause to reduce the lifespan of the product. Is this something anyone else has noticed?
Hello, I'm trying to make a borderless 11 X 14 print with my Pro-300, it appears it's not possible? When I go to create this print size, it's inputting minimum border sizes-very frustrating, since I need it to be borderless.Any insight on this questi...
I have a new PRO-310. I recently printed a picture from Adobe Photoshop onto heavy artist paper. The print was beautiful with deep saturated colors. When I tried to print another, the colors were faded. I printed two more with different settings and ...
The Mac installation process winner: Steve 1, Printer 0, but it took a lot of fighting. Truly awful documentation and installation software. I won't bore you with the details, but I ended up with the AirPrint driver and only until I added the printer...
Hi! I am attempting to print on a custom sized envelope on my Canon Pro 200S, but I cannot get it to print. It's a 5 x 5.75 area that I would like to print on. I made sure that the design I saved from my design software is a 5x5.75 and I've added it...
When I print on tracing paper, the printing stops halfway through. Does anyone know what I can do?
Pro9000i Mark II crops image, not printing the entire image (only about 70%). When printing on 13 by 19 paper, image stops printing at 13.5 inches on paper. Same issue with 11 by 17. Smaller sheets print completely and with correct aspect ratio. Usin...
Hi, I’m having an issue with my Canon Pixma Pro‑200S printer and I’m hoping someone might recognise the problem. I’m printing on 350gsm A3+ heavy art paper with a narrow (around 1.25 mm border) on the sides. On every print, I’m getting a shadowed “gh...
After close to 6.5 hours I have given up. I am not technology savvy. I take a lot of photos and I just upgraded to the 1100. It was working very well using canon paper. However, today, I attempted to load custom paper(Hahnemuhle), but as many times a...
Hi all, in the coming summer time my 1100 will not be used for two and a half months. During this time for all sorts of reasons I will not be able to run periodic print tests. Moreover, the printer stays in an environment that will likely get hot (30...
I was changing out my ink and when I opened the door I found this pin or rod. I added a picture where I found it. I looked through the printer but could not find anything obvious. Does not seem to affect operation. Can anyone indentify it? Your ...
Hi, I recently purchased a second hand Canon Pro 1000. I previously had a Canon Pro 300 and was having no issues with software, colours or anything printing on Canon Pro Platinum Glossy paper. I picked up the Pro 1000, got it home, ran all of the mai...
Hi all, I am in the middle of a rush print job and am experiencing intermittent buckling on a Canon PIXMA PRO-200S . I am printing on custom-size sheets measuring 4.125" × 5.375". Approximately every other or every third sheet develops a sharp buckle...
Why is it impossible to get repair information for my PROGRAF PRO-1100? This is not a cheap printer. Nothing I do on the support website leads me to anything that directs me to help. This is an abvious attempt to give me and others the middle finger....
