Desktop Inkjet Printers
Showing results for 
Show  only  | Search instead for 
Did you mean: 


TS9020 Taking too long to print

I purchased the TS9020 last year after my old trusted Canon printer died. I always liked Canon printers but I'm having problems with printing speeds - it takes too long to print. I use this printer as a small business tool and it's becoming more of a...

Pixma MX 920

The last cartrdge C is stuck in my printer, the rear seems higher. It had been printing fine. I ran out of ink. I removed all the other cartridges, carefully tried to remove it (3)hours, usngrocking it our prying it from the bottom. I tried to remove...

mlevick by Contributor
  • 2 replies

Receiving Faxes on my PIXMA MX340

I never had a problem receiving faxes until AT&T made a change in my phone service. I have been told that AT&T is moving toward getting rid of their copper wiring, and unbeknownst to me they changed my phone service. However, I can send faxes, so it ...

Error 5100 Pixma MG6120

Unable to send print dataSupport Code : 5100 A printer error has occurred. Turn the printer off and then on again. If this doesn't clear the error, the printer needs repair. See the manual and contact the service center.The thing is . . . I have unpl...

kurango by Apprentice
  • 2 replies

Canon PIXMA MG3620 Sends blurry Scans

    I NEED HELP W/SAME MODEL, BUT FIRST A RESPONSE. I wondered the same thing about the 3620 when the scanner had a blank line. In the help section, it said the printer description includes the scanner. BUT I AM POSTING HERE FOR ANOTHER PROBLEM WITH ...

eyewryt by Apprentice
  • 0 replies

TS3150 Windows 8 Compatability

Help wanted ref to model TS3150 Just purchased and cannot find any drivers for it as it appears to be not compatable with my Windows 8 Pro 64 bit if only it stated it on the Box,,,, any help is most appreciated   cheers  

Vidcare by Apprentice
  • 2 replies

MG2550 won't print full A4 sheet

I have a Canon MG2550 which won't print a full A4 sheet, it cuts off the last centimetre leaving a gap at the bottom of the page which is rather frustrating.  I had given up on this printer but have now had to start using it again. I have gone throug...

PaulineD by Apprentice
  • 1 replies

MX892 "wrong print head"

So I've been getting this general Printer Error and I looked it up and it looked like the most common cause was bad/old ink. So I replaced all ink cartridges and now I get a new error! U052 incorrect print head it's not the incorrect print head, it's...

Resolved! mx300 wont print photo on glossy paper

I can print normal stuff like pdf documents on plain paper. When I try to print a photo on glossy paper (4x6), the photo paper loads and you can hear the printhead working but the paper comes out blank. I run through the menu and adjust all the setti...

jmc0475 by Contributor
  • 9 replies

Pixma iX 6820 paper sizes issue

the Pixma iX 6820 is a very nice printer.  However, my big complaint is that using "nonstandard" (non standard to Canon) paper sizes is a pain.  Apparently even savng a file with all the print info doesn't mean that 4 or 5 steps aren't needed to use ...

Model 5700 not printing

I have a Pixma 5700, 6 months old. When I turned it on this morning, all was normal, reset ready to pring. I sent a text to the printer and it acted normal, (all the normal noises) but when it came time to print it spit out blank paper. i checked the...

papercut by Apprentice
  • 2 replies
Getting started

New to the community? Here's some information to help you get acquainted:

08/18/2023: Canon EOS R5 C training series is released.

07/31/2023: New firmware updates are available.

CR-N700 - Version 1.2.0

CR-N500 - Version 1.3.0

CR-N300 - Version 1.3.0

CR-X300 - Version 1.1.0

06/30/2023: New firmware version is available for EOS-R5 C

05/31/2023: New firmware updates are available.

EOS R6 Mark II - Version 1.1.2

EOS R6 - Version 1.8.2

EOS R7 - Version 1.3.1

05/18/2023: New firmware updates are available.

EOS Rebel T100 - Version 1.1.0

EOS Rebel T7 - Version 1.2.0

EOS 5D Mark IV - Version 1.4.0

EOS 6D Mark II - Version 1.2.0

PowerShot Elph 360HS - Version

PowerShot SX420 IS - Version

PowerShot 620 HS - Version

PowerShot SX720 HS - Version

PowerShot G1X Mark III - Version

PowerShot G7X Mark II - Version

PowerShot G9X Mark II - Version


04/20/2023: New firmware version 1.4.1 is available for EOS R3

03/30/2023: New firmware updates are available.

EOS R5 - Version 1.8.1

EOS 1DX Mark III- Version 1.7.1

Speedlite EL-1 - Version 1.0.2

03/30/2023: Product Advisory for EF50 F1.2 L USM

03/30/2023: Product Advisory for EOS R10

02/24/2023: We've updated Share Your Photos

2/07/2023: New product announcements!

EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
01/09/2023: Help ensure your autofocus is properly aligned with a Canon Precision Alignment
01/03/2023: Welcome to CES 2023!
12/08/2022: New firmware version is available for EOS C70
12/07/2022: New firmware version 1.7.0 is available for EOS R5