How to Get the Most from Canon’s Software Tools for its Professional Inkjet Photo Printers Getting a print to match what you see on screen isn’t magic - it’s a process. And a big part of that process happens in the software. Whether you’re using the...
Purchased this Jul 5th, 2024. It is just outside warranty, with less than 600 pages printed and of that, maybe 80-90 photos. Did not use printer Dec 24' to May 25' due to extended travels, returned, figured it sat that long it would need new ink, ord...
Running on an older Mac. Never had this issue. Printing on a PRO-1000. Printing greeting cards. Printer is printing some odd random magenta lines. Short and heavy. Vertical. sometimes one line, sometimes as many as four so far. here are pictures. T...
When printing black and white images, does checking the box "Print Black and White" actually make a difference? What does this setting do? Thanks for your help. Nelson
Hi all. I am using a Prograf 310. When I first setup the printer I was getting a violet ghosting when I would print blue images. I cannot remember what I did to correct the problem, but it corrected. It is happening again. I did alignment and ran noz...
I have a Pixma Pro 200 printer. It prints fine when using other programs, however it won't print photos from Photoshop Elements. I get the following message: "Print data cannot be sent because of the current printer status. Check that the printer...
beginning of printend of printbeginning of printWhen I print on format A2 I get horizontal lines at the beginning and end of the print, the first and last 5 cm of the print, see photos. In between the print is perfect. The paper I use is Canson Bary...
OK, so I have been successful in doing this with every other printer that supports disc printing but I can not for the life of me figure it out on the pixma pro-200. I have tried setting up the custom media, PP&L, etc and even software from the pixm...
I bought a used Pixma Pro 10 which came with original cartridges. Tried starting my first print and the printer said a few were done. I tried to unseat and re-seat the cartridges and ALL the red lights stop flashing. The printer then tells me none o...
I have had a PRO100 for eight or nine years, and it finally just stopped working. Previous posts are from the old printer. I gave up on so many tries to get it to Work. Just recently. I was lucky enough to find a PRO100 for sale. The printer was in a...
Hi all, just switched from Epson units to Canon. Really happy so far to not be dealing with constant printer issues, could use a little help with this though. Picked up a Pro-4600 and a Pro-1100, no issues with the 4600 she was good from the first ...
New Pixar Pro-200S Network Configuration Page: 1. shows Wireless Signal Strength at 81% 2. Wireless Connection as Active My Mac laptop shows this printer as Offline & thereby unable to print to. My...
I have a Pixma PRO-100 with firmware 1.040, trying to update to 2.031. It fails with the following message:"Send error occurred during the printer function update."I do see it go through the process of verifying the existence of the printer, includin...
I just replaced all the ink cartridges for my expensive Pro9000 Mark ll printer, that I've had for about 15 years (kept covered except when using), with expensive genuine Canon inks. Was able to print two exquisite photos on expensive Canon papers, t...
When printing to the manual feed on the back of the Canon Pro-1000, you have to walk over to the printer after you've printed and press "OK" to activate the print job. Is there a way to disable the printer asking me to press Ok to the print job? When...
Is there a way when printing a photo that is smaller than the paper, but needs one full dimension of the paper, to print the photo to one edge. Call me cheap but I would like to put two photos on one piece of paper.
