How to Get the Most from Canon’s Software Tools for its Professional Inkjet Photo Printers Getting a print to match what you see on screen isn’t magic - it’s a process. And a big part of that process happens in the software. Whether you’re using the...
beginning of printend of printbeginning of printWhen I print on format A2 I get horizontal lines at the beginning and end of the print, the first and last 5 cm of the print, see photos. In between the print is perfect. The paper I use is Canson Bary...
OK, so I have been successful in doing this with every other printer that supports disc printing but I can not for the life of me figure it out on the pixma pro-200. I have tried setting up the custom media, PP&L, etc and even software from the pixm...
I bought a used Pixma Pro 10 which came with original cartridges. Tried starting my first print and the printer said a few were done. I tried to unseat and re-seat the cartridges and ALL the red lights stop flashing. The printer then tells me none o...
I have had a PRO100 for eight or nine years, and it finally just stopped working. Previous posts are from the old printer. I gave up on so many tries to get it to Work. Just recently. I was lucky enough to find a PRO100 for sale. The printer was in a...
Hi all, just switched from Epson units to Canon. Really happy so far to not be dealing with constant printer issues, could use a little help with this though. Picked up a Pro-4600 and a Pro-1100, no issues with the 4600 she was good from the first ...
New Pixar Pro-200S Network Configuration Page: 1. shows Wireless Signal Strength at 81% 2. Wireless Connection as Active My Mac laptop shows this printer as Offline & thereby unable to print to. My...
I have a Pixma PRO-100 with firmware 1.040, trying to update to 2.031. It fails with the following message:"Send error occurred during the printer function update."I do see it go through the process of verifying the existence of the printer, includin...
I just replaced all the ink cartridges for my expensive Pro9000 Mark ll printer, that I've had for about 15 years (kept covered except when using), with expensive genuine Canon inks. Was able to print two exquisite photos on expensive Canon papers, t...
When printing to the manual feed on the back of the Canon Pro-1000, you have to walk over to the printer after you've printed and press "OK" to activate the print job. Is there a way to disable the printer asking me to press Ok to the print job? When...
Is there a way when printing a photo that is smaller than the paper, but needs one full dimension of the paper, to print the photo to one edge. Call me cheap but I would like to put two photos on one piece of paper.
If the pro 200 replaces and 100 can anyone tell me why and 100 is more expensive? The 200 seems extremely similar? Buts its newer and cheaper? Is the 100 better? What does the 100 have that the 200 doesn't. Confused!!
I'm looking at you, Legend... I have a Pixma Pro-100, and it's been in a closet for probably 5 years or more, just didn't have the need/space for it. Between 51-100 pages on it, which I discovered when printing an alignment test on it today. (The tes...
Hi Community,I have a shiny new Canon Prograf Pro-310. When I try to print borderless 4x6 prints, the fist row of pixels (i.e. the first pass the print head makes when printing an image) does not print. I end up with a thin white band down the edge o...
usb install for Canon Pro-310 on my Mac Book Pro M1 with Sequoia. I am having no luck! Thank you!
Hi all,Hoping someone here has seen this before. I just unboxed a brand new printer that’s been sitting in sealed storage since 2020. Setup went smoothly, and I installed the original ink cartridges (still sealed and unexpired). All colors are printi...
