Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

PIXMA MX922 Set the PC to start scanning

My PC was previously set to scan, but I'm now getting the message "set the PC to start scanning" and don't have a clue how to fix this.  I'm not savvy enough to navigate through a ton of steps.  I need something simplified. 

PIXMA MG2522 Paper Jam Error

Hi, I have recently purchased a PIXMA MG2522 printer. It was working this morning, but then it suddenly got a mysterious paper jam! There is no paper in the printer and I have not been able to figure out what may be causing this ghost paper jam. Rein...

PIXMA TS8320 locks up when powering off

My printer is 2 years old and I recently switched it from using USB to WiFi. Now, when the printer tries to power off, it locks up and won't respond at all, requiring it to be unplugged. Even after waiting overnight, it still won't power down. This a...

LloydGM by Apprentice
  • 1602 Views
  • 3 replies
  • 0 likes

Printer Pixma MG2522- Paper Jam Error

I keep getting an error message that I have paper jam. There is no paper in the printer. I've attempted in turning off the printer, unplugging the printer, etc. but I continue to get a paper jam error. Any suggestions?  

JC81 by Apprentice
  • 11283 Views
  • 8 replies
  • 2 likes

Resolved! Canon MG2522 with bank checks

I want to print on standard pre-printed bank checks but the MG2522 adjustable paper guide does not move far enough to the right to properly guide the checks (2.75 inch wide). Because of the gap, the checks turn slightly while feeding. Is there a work...

jf92647 by Apprentice
  • 1729 Views
  • 2 replies
  • 0 likes

TS9120 Just started cutting off bottom of page

This is only happening when printing.  Scanning is fine.The bottom inch of the page is consistently cut off when I print on my TS9120, regardless of the application from which I am printing. This problem emerged suddenly-- the printer had worked OK p...

scottdm by Apprentice
  • 1884 Views
  • 5 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements