When I set the front load tray for 19 x 13 paper : my steps are turn printer on set front tray for front feed, wait for green top light to stop flashing and then push smaller green light, when it starts flashing I can put the large paper in. This wor...
I tried asking this yesterday, but my post seems to have been deleted.I have recently reinstalled Windows 7 and the most recent version of the printer driver.If an ink cartridge is low or empty, I am not getting the normal pop up, the one that tells ...
Our Pro9000 MKII is using color ink, specifically cyan and magenta, when we print only in grayscale. All cartridges were full a couple of months ago. Not so much as one color page was printed, only grayscale. We use color for photos only, and we h...
I have just purchased a Canon Pixma Pro100S Printer - I cannot get Photo Studio Pro to download to Adober Photoshop CC2018. It works on Lightroom but does not appear om Photoshop - I've tried downloading it several times and each time it tells me tha...
I have a 2008 printer and am using genuine Canon inks, Fotospeed papers, using a USB connection and Windows 7. Sometimes it prints beautifully, sometimes it ejects the print part way through for no obvious reason. It can be after a cm or 2, half way ...
A new 80D has caused a ripple issue with all software. New HP PC, uploaded updated software. Now Canon Image Garden software is saying the Pro-100 is not connected? It says "a printer supported by t his software is not installed" I can print to thi...
I just got the printer, did the alignment and copied the plugin from 2017 to the 2018 folder. This is my first print test, attached settings and photo of the print.(Photoshop CC 2018 with Canon Pro Plugin - firmware updated) the print was out within...
Dear all, I have a problem with my canon pro-100 printer.Suddently, without changing ink or paper when printing in a3+ everything goes perfectly well until the last one or 2 centimeters where i can ear gridding sounds and at le extraction the picture...
I just bought the Pixma 100 and I have no problems printing from proprietary software on my PC, but for some reason it will not print from photoshop on my Macintosh. I have updated all the drivers and still it does not see it.
Have no clue why it started doing this. I havent had any problems when i resized in custom before. Any help would be appreciated.
I am well pleased with a Canon i9900 that I decided to upgrade to Pixma Pro 10. I have made several prints with the new Pro 10 and the prints are way too dark and very muddy looking. I have printed the same images on the i9900 for comparison and I ...
How many mili liters are the CLI 42 cartrages when new? Thanks Bill
Hi forum! I'm a new owner of a Pro-100. I previously had a Pro-9500 Mark II. I have a symptom of having a kind of purple color cast to my darker values, on several test prints. I have printed with photoshop and just simply apple's photo app - same re...
I can't print because it believes there's a jam, but there isn't. I've shaken the printer, turned it off an unplugged it, fed card stock through it, blasted it with compressed air, etc.. nothing works! Can I disable the stupid error and continue pri...
My print head stopped working and I bought an offbrand replacement which looks just the same, but when I went to install it I got a message that the head is a non-Canon print head. Is there a way to get the printer to accept the print head?
