Hello,My Canon Pixma Pro 100 prints smaller photos just fine up to 11 x 17.I'm using Mac OS Mojave 10.14.5. Printing from Photoshop CS 6. I don't see a choice for 13 x 19 in the dialog. Following some bits of online advice.... I've reinstalled the l...
When I print from photoshop, I setup for a 13x19" paper size and 13x19" print size. But when the image prints, it leaves about a quarter inch margin all the way around. I would like to cut that at least in half. I cannot find a setting that is cau...
I have a Pixma Pro 10. When I print on non-Canon papers, I notice odd printing irregularities, especially in the sky. The blues in the sky lack the subtle tonal gradation that is clearly present when the image is viewed on the monitor, the colors are...
there are several paper type settingss....I am trying to print on a water color paper...I've noticed with different paper types - for instance - envelope versus photo glossy......the colors are way different...what is the best paper type setting?.......
Hi There and thanks in advance.Would someone be able to confirm if I am setting up the print steps correctly please as I am not happy with the end result.Please see image showing what I am doing.Photoshop cc – Canon imageprograf IPF6400 - hahnemuehl...
I have had the Pro 100 for 2 years and 3 months. It comes on, but the orange light blinks, it gives a "screechy and scratching noise", shakes pretty bad and then stops doing anything. I have tried everything i know to solve the problem. Does anyo...
I just purchased a Canon Pixma Pro-10. It replaced my Pro-1 that took a dump. I print a lot of 8x10s. Sometimes my printer prints blanks of photos that I know I was able to print with my Pro-1? I don't understand. Is there a way I can change the...
Posting to see if anyone else has been having any issues of (15 mil) Scrim Vinyl Banner prints not drying properly from the Pro series? We have updated the media profiles (thru MCT) on both the plotter and driver to no avail. Anything printed on this...
I would like to know if anyone with this printer has had a similar message appear after performing an auto alignment?This printer was just set up days ago and arrived damaged from shipping to the bottom guide assemblies. In the meanwhile I have set u...
Hi guys. I bought a PRO-100 off a person yesterday. The said person had the printer for over a year but never used it. All the orange tapes on the printer were still on, and the cartridges were sealed. However when I setup the PRO-100, in the nozzle ...
This printer doesn't get used very often. Only printed about 100 photos of mixed 4x6 and 5x7. The 5x7 never jam but now the 4x6 jam every single time, it's so frustrating! I tried putting in 1 at a time, tried putting in a stack, full capacity, but n...
I am using a Canon iX6820. It was printing fine with the ICC profile sRGB IEC61966-2.1. But after installing a new printer (the same model just a newer one), I had lost the printer profile. I downloaded again and put it in the correct folder Library...
I have a Canon Pro-4000 and I am printing a 42"x42" image onto 44" roll paper, but when the image is printed it is coming out at 41.75" high, compressing (not cropping) the image by a quarter inch. I didn't notice the problem until I took an image to...
I am attempting to print graphics on paper 13" wide by 26" high. I get the following message:"media type paper size are not set correctly" I don't understand. Only one way to set media type and paper siz. Using Adobe software In-design.
Hello, I have a Pro 100s printer and I have been using the Print Studio Pro plugin for lightroom. However, when I open a lightroom file it automatically says the image resolution is 240dpi, regardless of the image resolution (in this case 8021x3582) ...
