Production Printing
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

PRO-4000 - yellow discolouration on print edge

Recently our Canon PRO-4000S has started leaving a band of yellow discolouration (approx 5cm wide) to the lead edge of the print. It only occurs when the printer has been idle for a period of time, ie. first thing in the morning, or after a break. It...

Skit by Apprentice
  • 871 Views
  • 1 replies
  • 0 likes

Resolved! Ink stains on my prints using my new Prograf pro 4100

I have a Prograf Pro-4100 that drops ink on everything I print, right now I am printing on Hahnemuhle Cézanne Canvas Matte, base weight: 430 gsm and thickness: 20.5 mils. This started to happen after printing about seven 34 x 44" photographs, I clean...

Canon Pro 4100 will not power on.

I was printing a job a few days ago on the canon pro 4100 all of a sudden the printer turned off during the job and will not power back on. I think it may be the power supply? any input/ advice to resetting or fixing this issue would be greatly appre...

imagerunner advance DX diagonally fed sensor

Every day, I have to scan in checks at my office, which're varying sizes. With my office's old printer, you could load them up, and they'd scan. Now, I'm getting "Originals may have been fed diagonally. Check the following:" Then it gives the option ...

wallace3 by Apprentice
  • 611 Views
  • 1 replies
  • 0 likes

imagePROGRAF PRO-6100S Stops and Cuts Prematurely

Hello! I’m printing a 5’x10’ banner ImagePROGRAF 6100 and the printing stops before the job is completed and automatically cuts the paper. This has never happened before and there’s no warning so I’m not sure what’s going on. Any ideas? Thanks!

danhorse by Apprentice
  • 743 Views
  • 2 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements