03-01-2024 04:05 PM
Recently, my Pro 4000 printer has been leaving a black wet blob in the top right corner, which causes the print rollers to leave dots until it dries up. I suspect it might be the print head, but I replaced it only 18 months ago. However, I noticed that the little drain and squeegee in front of the print head was full the other day, and it took a lot of towels to soak it up. So, could be it the head leaking and not draining, or there might be some other issue?
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.