Printer Software & Networking
Showing results for 
Show  only  | Search instead for 
Did you mean: 


Cannot start MP Navigator EX

I switched ISPs and got a new laptop.  When I tried to install MX870 software, I got errors because the MP drivers installed on my new laptop were newer than those on the softtware CD.  I did a custom install and did not install the MP drivers.  I've...

cannot get wireless printing to MX882

The printer sees the router and has connected to it. I've installed the wireless driver (seemingly) successfully. When I go to print, the driver options don't indicate wireless in any way (should they?) and when I choose the printer, it says the prin...

Printer wont connect to access point

I have a Canon MG5560.  Last night my ISP was down and since it has come back online I am unable to get my printer to connect wirelessly.  It can see my access point and will allow me to select it but once I enter the password it comes up with "faile...

MX922 wireless LAN setup problems with iMac

I am trying to setup my new MX922 printer with a new imac. During the original setup phase, I got a message instructing me to press the "WPS" button on the "access point" for 3 seconds. Before I could figure out what the heck either a WPS button or a...

Toeknail by Apprentice
  • 3 replies

canon mg3122 sleep mode

I have a Canon MG3122 wireless printer that i have connected to a Windows 7 PC and a Mac OSX10.6,every time I want to print I have to go turn the printer on and off then back on for it to connect to the network and allow me to print. This is very fru...

Getting started

New to the community? Here's some information to help you get acquainted: