Last evening we experienced a brief power outage of less than two minutes. Today when I sent a document to be printed nothing happened. My computer is running Wondows 10, 64-bit. For some reason the network status showed 198.168.1.2 while the port...
No matter if I print or copy, there is about a 1 1/2" margin that doesn't print on both sides of a letter sized piece of paper. NOTE: I am not talking printing on the back, just on the top of the page. It prints right down the middle fine, but cho...
I'm looking into purchasing an ImageCLASS MF744Cdw printer to replace a Ricoh AIO we are not satisfied with. Despite having a high capacity black toner cartridge with plenty of ink, we have to fight with our printer to print in B&W if even one of the...
Hi folks. I reset my MF645Cx trying to get it onto our network. (That’s a long story for antoher day.)Now the printer will not print without a sheet of paper present in the MP tray.How to configure the printer to pull from Tray 1 first? (Or is this a...
I am trying to print a photo and cannot even find an option to print borderless. Does the MF642 print borderless and if yes, how? TIA!
keep getting a error support code 5011 need help
I've only got about 6 hours into this nightmare. My scanner quit working after my beloved ISP had a hicup.I have my MF4890DW set up on Ethernet and it prints just fine, but it will not scan. I've reloaded all the programs and updates including the pa...
Hello:Brand new to the forum - just installed printer this afternoon. From my computer, all is fine - prints beautifully. From my wife's computer, all appears well - drivers downloaded, can hit "print" button, and diagalog box shows printer working. ...
All the time, it gives me many print outs unless I stop it manually. In addition, it does not print out properly. Right end is always missing. I really want to have helps for these issues.
I've used the color printing option before and had no issue, other than the ink smudging a little on dark tones. But I haven't printed color in about 2 months and now it will only print in shades of gray, black and white. The cartridges are still mos...
I have been trying to get my printer to scan to my email with no luck. My email is a gmail so I am not sure I am settign the remote UI up correctly. A few discussions I have found was to set the port, but there is no entry for port allocation. i was...
I cannot figure out how to duplex scan on the MF744cdw. Any suggestions?
I keep getting an error message when trying to print from my LBP622CDW. Connected via a wireless connection. Tried installing the printer following the task but get non-specific error message. It's never printed and brand new. ThanksAdam
Greetings all,About a month ago I needed to replace the right printhead. All seemed to go well until adjusting the printhead. It would not complete the alignment no matter what I did. Printing a nozzel check all looked good except the black line. Aft...
Hi i need some help if possible. i have a Surface Pro X which uses a windows 10 64x ARM. im finding that this might be causing the issue but any help is appreciated. i cannot install the driver for this printer online. it just promts "Could not insta...
| Subject | Author | Posted |
|---|---|---|
| 10-15-2024 07:13 PM | ||
| 10-14-2024 06:56 PM | ||
| 10-14-2024 01:22 PM | ||
| 10-13-2024 12:24 PM | ||
| 10-10-2024 12:39 PM |
New to the community? Here's some information to help you get acquainted:
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.
