Canon Community

mx712 stopped printing and showed error code b200

I need the printer drivers for Windows 7 (64) for the PIXMA iP90v. Any ideas would be appreciated.

I need the printer drivers for Windows 7 (64) for the PIXMA iP90v. Any ideas would be appreciated. The online site for downloading drivers doesn't list the drivers for windows 7. Is the printer too old for windows 7?

PIXMA MG8220output tray door will not open automatically when printing starts

My MG8220 output tray has stopped opeing automatically when printing starts. It had been working fine and now I have to manully pull down. Is there a sensor that need replaced or what else could be causing this? Thanks

paper feeds back in after printing

Hi I have a MG5750 I use edible paper in it, it has worked fine for months until I had a paper jam, now it wont print and rerolls in the last 1.5". So far i've  uninsulated and reinstalled the printer. it works ok on 80grm paper, but that's not what ...

MG7520 will sometimes not print text

I have a Canon MG7520. Ever since we purchased it, it will have certain print jobs where I cannot get it to print text. I think it has something to do with the settings for the black pigment ink cartridge, but I cannot figure out what. Sometimes I ca...

MG6150 not showing MacBook on Control panel

Hello I have a Macbook Pro (El Capitan) and a Dell Laptop (Windows 7) connected to a Canon MG6150 print/scanner via a wireless router. I can print from both Macbook and Dell wirelessly  When I try and scan a document, the MG6150 control panel only sh...

My Canon ix6800 goes offline after one page of printing.

I purchased my wife a Canon ix6800 for her vinyl work and pictures. It worked great for the first couple of months, but then it started going offline when it wasn't. It would also show as being wireless but when we went to print it would only print o...

Pixma MG6220 scanner and MP Navigator Ex stopped working

I have a Pixma MG6220. I am running windows 10. I have been printing and scanning over wifi for quite a while. The scan feature has suddenly stopped working. I can still print over wifi. I noticed that MP Navigator Ex will not launch. No errors repor...

TS6050 doesn't always print

I have just purchased a TS6050. I can print from my Macbook, but I also use a work Windows laptop at home. I have installed the driver on the Windows laptop and I have managed to get two documents printed, but it took several attempts to get them. A ...

Re: Error Code B200

Hi there,I have a Prixma ip8700 everything was printing fine when ink ran out. I changed the ink in same way I have done onnumerous times before. Then the B200 code appeared. Ive tried the usual advice of unplugging the printer etc etc.But there seem...

I lost my installation disk for my canan MX350 how can I download it

Re: how to prevent my printer from shadowing the character

windows 10dell laptopCanon Pixma mg5420Support Code 5100Says to stop printing.and i can't clear the code.the Printer is not printing anything

my canon mp610 printer lost power

My canon was on and just lost power . cant get it to turn back on .  waited 20 min to try to get it to tuen on but no luck.  tried different outlets with no success.  Any solutions?

My Cannon 490 will not scan to my PC ..Printer works fine.

My Cannon 490 will not scan to my PCGateway Computer..Windows 10

MP640 incorrectly calculating ink levels.

I get the pop up telling me My ink tanks are empty when in fact they are at half full or better.  I tried removing the half full tanks and rein stalling but no use.