Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Blurry texts

After a paper jam, I've also noticed blurry, squiggly lines.  I did not remove it aggressively and removed it from the bottom.  I saw another question regarding the same thing. 

Canon Mg5420 Not Loading 8x10 Paper

My Canon mg5420 is refusing to print on 8x10 photo paper. It only grabs the paper a little bit and then continues printing on nothing until it gives me a paper jam error. It has no problem printing on letter size paper of the same weight. The 8x10 ph...

juroara by Apprentice
  • 141 Views
  • 0 replies
  • 0 likes

Can Pixma G3200 be used for sublimation?

I recently bought the Pixma G3200 so I can print out sublimation for the tumblers I am going to be making. I set it up, but each time I print the papers look like a lighter pinkish when I bought it; it said it was for sublimation printing, but I'm st...

Mono by Apprentice
  • 3614 Views
  • 4 replies
  • 0 likes

Canon Pixma G2411 Black Ink error

Whoever can assist here would be a miracle worker. I have a Canon Pixma G2411. I was printing some pages on normal paper (which I always have), with a black background. There were a couple lighter streaks in the black, but barely visible. A week late...

IMG20231208070052.jpg

Blues print gray - G4270

I just purchased a Canon G4270.  The colors are great except blues come out gray.  This includes teal/greenish-blues - all gray.  I cleaned nozzles, just to make sure that wasn't an issue.  No resolution.  I am just copying from the flatbed. Thank yo...

jajarvis by Contributor
  • 519 Views
  • 6 replies
  • 0 likes

Canon PIXMA G4511 Printing Blank Pages

I am having an issue where when I try and print from my Mac (Ventura 13.4), or any other device I have tried the prints come out blank.As far as I have tested this has nothing to do with the ink or print head, photocopying from the printer works fine...

robbie1 by Apprentice
  • 269 Views
  • 1 replies
  • 0 likes

IP8750 PGBK printing blurred

When I print using my IP8750 printer, the black (PGBK) text is blurred.The nozzle check page shows the PGBK grid section at the top but the vertical lines are doubled in the centre (BK is apparently OK). Deep clean cycles and head alignment do not so...

andydav by Apprentice
  • 195 Views
  • 0 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements