Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

PIXMA TR7020a Spotty Wireless Connection

I just Purchased a TR7020a Recently and have been experiencing 50/50 Connection (Moody).. I have been in contact with a Canon Tech, it's a Wireless Connection both Printer & Laptop.. It was suggested the Printer is to far from the Modum(20'/25'at mos...

NorPlan2 by Contributor
  • 655 Views
  • 1 replies
  • 0 likes

Resolved! PIXMA MG6320 Printer doesn't print the entire page

Printer doesn't print the entire page.  It started out small where letters here and there would not print but now it only prints 50% of the document.  It's either blank and you can't see the letters or it's smudged.  But when I save the document as a...

Sonko84 by Apprentice
  • 816 Views
  • 1 replies
  • 0 likes

Resolved! PIXMA MX490 How to Enter the Numbers in My Passphrase

MX-490 I had my wireless router replaced due to issues with the previous router. I don't have a WPS button on my new router, I tried doing a manual setup from the printer display, it finds my router network just fine, I choose it and it then asks for...

v123456 by Apprentice
  • 5855 Views
  • 2 replies
  • 0 likes

PIXMA G3202 Ink Absorber Almost Full Error Code

My PIXMA g3202 gave me the "ink absorber almost full" error code. Canon is unwilling to share with the consumer how to reset the error code even when the pads have been replaced. Repairs will cost more than a replacement printer I am told. But hey, h...

rjf1970 by Apprentice
  • 1060 Views
  • 0 replies
  • 0 likes

Resolved! PIXMA MG5300 all printing is pink

Just replaced the ink 2 weeks ago, in the middle of printing it went from black to pink and it's been pink every since. I do not refill the ink, only buy new. broke down and bought new black ink again, the color ink is showing full, black is still sh...

DOOLEY33 by Apprentice
  • 166910 Views
  • 22 replies
  • 3 likes

Canon MP490 Printer Jammed

I have had a Canon MP490 for a long time and never had problems using it. Now I can't print anything because the printer is jammed. Any helpful suggestions on how to clear the jammed paper so I can start printing again? 

gtyson27 by Apprentice
  • 456 Views
  • 1 replies
  • 0 likes

PIXMA MX392 Stuck in copy mode

Greetings, I have an old MX392  that just made a large number of copies for the first time.  I've had it for years but used it 99% of the time for printing and scanning.  The problem I'm having is that it's stuck in copy mode and not being detected b...

Getting started

New to the community? Here's some information to help you get acquainted:

Announcements