03-23-2021 09:24 AM
I have a new MF644cdw that has had a problem since we got it a few months ago. When using the document feeder, it pulls in the paper unevenly / at a slight angle. The result is it bends the right corner, and makes little 1-inch tears (and creases) along the opposite edge (bottom left) when it comes out after scanning. In addition, it does not always scan the documents straight, so they come out a little off when the image is printed or scanned. So my guess is that the right side is applying more pressure when the paper first goes in. Any suggestions?
05-12-2021 05:03 PM
Thank you for the link and the advice.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.