02-02-2023 11:23 PM - edited 02-02-2023 11:27 PM
Every time I print a 4" x 6" photo, it's always is off centered. The source I print are always 4" x 6" (2100 x 1400 px), but the source itself doesn't seem to be cropped in any way. I'm pretty sure I'm using the correct preparation, glossy photo, and size. Is there a borderless option to print or anyway I could fix this?
02-27-2023 07:34 PM
When printing on 4X6 the top and bottom margin as the printer feeds out of the printer will be different. The margins will be different by 2mm. You can check the printable area/margin specifications for the printer from our knowledge base using the link HERE.
02-27-2023 07:59 PM
If you want even borders you must set all margins to be equal to or greater than the printer imposed margins explained in hector's posting.
That will sometimes result in a slight change in the aspect ratio, requiring some cropping. For example, for 4x6 paper with 0.20 margins all around the print area would be 3.6 inches by 5.6 inches. Aspect ratio would be 1.55 vs 1.5 inches for straight 4x6.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 22.214.171.124
PowerShot SX420 IS - Version 126.96.36.199
PowerShot 620 HS - Version 188.8.131.52
PowerShot SX720 HS - Version 184.108.40.206
PowerShot G1X Mark III - Version 220.127.116.11
PowerShot G7X Mark II - Version 18.104.22.168
PowerShot G9X Mark II - Version 22.214.171.124
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.