10-19-2020 10:37 AM
I enabled R6 multi-controller through the customized buttons, but I don't see anything happening in the viewfinder or LCD when I press it. Wondering if I am missing something? Any guidance on its operation. Thanks.
10-19-2020 10:58 AM
@rk5212 wrote:I enabled R6 multi-controller through the customized buttons, but I don't see anything happening in the viewfinder or LCD when I press it. Wondering if I am missing something? Any guidance on its operation. Thanks.
Let's figure this out. What settings did you enable it to control?
10-19-2020 11:13 AM
Just the Customize buttons settings as shown below.
10-19-2020 11:44 AM
The screen says "Direct AF Point Selection".
Half press the shutter, to wake up the viewfinder, and then try it again.
07/24/2025: New firmware updates are available.
EOS R5 Mark II - Version 1.1.1
07/23/2025: New firmware updates are available.
7/17/2025: New firmware updates are available.
EOS R6 Mark II - Version 1.6.0
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
12/18/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.