Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Canon PIXMA MG3620 Sends blurry Scans

    I NEED HELP W/SAME MODEL, BUT FIRST A RESPONSE. I wondered the same thing about the 3620 when the scanner had a blank line. In the help section, it said the printer description includes the scanner. BUT I AM POSTING HERE FOR ANOTHER PROBLEM WITH ...

eyewryt by Apprentice
  • 1782 Views
  • 0 replies
  • 0 likes

TS3150 Windows 8 Compatability

Help wanted ref to model TS3150 Just purchased and cannot find any drivers for it as it appears to be not compatable with my Windows 8 Pro 64 bit if only it stated it on the Box,,,, any help is most appreciated   cheers  

Vidcare by Apprentice
  • 1969 Views
  • 2 replies
  • 0 likes

MG2550 won't print full A4 sheet

I have a Canon MG2550 which won't print a full A4 sheet, it cuts off the last centimetre leaving a gap at the bottom of the page which is rather frustrating.  I had given up on this printer but have now had to start using it again. I have gone throug...

PaulineD by Apprentice
  • 2536 Views
  • 1 replies
  • 0 likes

MX892 "wrong print head"

So I've been getting this general Printer Error and I looked it up and it looked like the most common cause was bad/old ink. So I replaced all ink cartridges and now I get a new error! U052 incorrect print head it's not the incorrect print head, it's...

Resolved! mx300 wont print photo on glossy paper

I can print normal stuff like pdf documents on plain paper. When I try to print a photo on glossy paper (4x6), the photo paper loads and you can hear the printhead working but the paper comes out blank. I run through the menu and adjust all the setti...

jmc0475 by Contributor
  • 9113 Views
  • 9 replies
  • 0 likes

Pixma iX 6820 paper sizes issue

the Pixma iX 6820 is a very nice printer.  However, my big complaint is that using "nonstandard" (non standard to Canon) paper sizes is a pain.  Apparently even savng a file with all the print info doesn't mean that 4 or 5 steps aren't needed to use ...

Model 5700 not printing

I have a Pixma 5700, 6 months old. When I turned it on this morning, all was normal, reset ready to pring. I sent a text to the printer and it acted normal, (all the normal noises) but when it came time to print it spit out blank paper. i checked the...

papercut by Apprentice
  • 2593 Views
  • 2 replies
  • 0 likes

Printer head alignment problem ip8750

I just bought an ip8750 printer to replace another ip8750. After printer head alignment there were some lines in the printed bars. On printing photos I could see some lines. I tried to do manual printer head alignment and saw that I needed to adjust ...

cyan and yellow won't print on Pixma

I have a Pixma TS9020.  I have all new ink, but everything prints pinkish from the magenta cartridge. I have cleaned the print heads (3x), deep cleaned the print heads and ran the print alignment.  No luck.  The cartridges are new cannon and show a f...

Getting started

New to the community? Here's some information to help you get acquainted:

Announcements