I'm getting some dark toner marks about 3/4" into, across my 8.3" wide panoramic prints. Pixma iX6820: This began after one of the panoramic sheets didn't feed, and the toner for the job welled-up inside the printer. I've gone through all the nozzle,...
I have a Cannon MG3650S inkjet printer why won't the cannon black ink not dry on kodak glossy paper
I am getting the 5 blinks error that my ink cartridges are not recognizable. I started getting this error with my existing cartridges after everything had been working fine, so I replaced them with brand new Canon brand PG-240XL and CL-241XL cartridg...
I have a Pixma TS3722 printer When I am done using it I used to be able to push the switch and it would shut down. Now I have to push the switch and it keeps on flashing. Sometimes if I push it enough times it might shut off, if it doesn't I have ...
My printer reports that there is 'no paper' when I try to print from Windows 11 for the first time. On the printer it says 'no paper in rear tray', which is correct but there is plenty of paper of the right size in the front casset. If I go into the ...
I have a Pixma 3260 which I didn't use for 2 months. When I returned to it I printed a few pages but none of them were good. The black faded and now nothing prints. When I tried to use the maintenance program it couldn't find the printer. I tried rei...
Just started doing this very clean slice in paper each time I print. Print quality is very good, no error codes, paper is not jamming or stopping. I have looked into printer with flashlight from every angle and don't see anything that might be causin...
Pixma G7020 set to grayscale printing but printing in red???
Bought the Pixma g6020 mega tank all in one printer a few years ago, and loved it. Best printer I ever had. I print often and usually in color, onto all different media types, such as paper, glossy and matte photo paper, printable vellum, printable g...
I just purchased and set up a Canon Megatank Prisma G3290 printer. Only problem is I can't see the ink levels. Does anyone know if there is a protective film over the tank windows or are they just dark?
I have a TS9520 printer and it won't print correctly on my windows 11 computer--all drives are updat
I have two MX922 printers and they both have the same error message B200. Can someone please help me?
Something was stuck in the paper loader so I pulled out that part and then a spring came loose and I'm not sure where it goes.
Although it appears I should be able to view the ink level on the front of my printer, they are all black. If this is caused by a protective covering, what is the best way to remove without damaging the printer?
