Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

MX922 won't fax . Used easy set up

Dial the number, phone rings and the recording says. Try again later cannot get through at this time. Does this no matter what number I dial. took it to my office and set it up and it did the same thing. I am using 8.1

Not printing

MY canon MX310,suddenly stopped printing,but will copy.I reinstalled the printer,no printing,followed many suggestions still nothing.Contacted my usual repair firm,they advised it could be a sensor.Suggested cost of  repairs would exceed $70,andbest ...

Henry8 by Apprentice
  • 2753 Views
  • 0 replies
  • 0 likes

Resolved! PIXMA IP8720

I recently connected a Canon PIXMA IP8720 to my MacPro running OS/X Yosemite 10.10.2. As much as I try, I cannot get the printer to product prints of photographs with the correct colors. The colors are way off and I've tried to coordinate the color p...

nicka by Apprentice
  • 5317 Views
  • 2 replies
  • 0 likes

size and resolution of pics

Just set up a new MX892.The photo quality has a hazy pale look to it when printed on reg. 20 lb paper.(the older printer, MX7600, did a better job.)When I print pics through the PhotoPrint EX, the quality is better but the pics are printed in 1/2 sca...

paulb by Contributor
  • 4707 Views
  • 3 replies
  • 0 likes

Resolved! MP530 problems with Yosemite

Aftger installing Yosemite my MP Navigator software never worked properly.  The app would launch and would interact with the MP530 but the buttons for attaching to email, save, etc were ghosts buttons.  So i deleted the app and tried to find it to re...

zanus by Apprentice
  • 3288 Views
  • 1 replies
  • 0 likes

Replacing the Canon Pixma MG5320

The MG5320 was the best printer I've ever had but it died after only owning it for a year. I got a B200 error and then it totally died and won't power up. I called tech support and they said I would need to replace it as it is probably the print head...

LAN Printer setup

Canon LMP6300DN plugged in LAN went to our print server windows server 2008 setup done but wat 2 do on the printer itself to recognise it? how to configure the printer with the I.P. as no LCD?

zaineyma by Apprentice
  • 2838 Views
  • 0 replies
  • 0 likes

MX922 ADF misalignment

HiIf I make a copy with the ADF the copy comes out shifted by about 1/4 of an inch. There is a line about 1/4 inch up from the bottom and the entire image is shifted up.Is there any kind of adjustment I can make? The printer is new.Thanks.

terryRI by Apprentice
  • 2990 Views
  • 1 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements