07-26-2022 03:14 PM - last edited on 07-27-2022 08:57 AM by Danny
My printer is misaligned. I have tried to clean the heads, deep clean the heads and realign it but it is still off. Any ideas? Thanks!
07-27-2022 09:08 AM
Hi,
Based on the steps you have already taken, I recommend reaching out to Canon support for this issue. You will need to register your Canon gear HERE to access additional support options.
We look forward to hearing from you.
12/05/2024: New firmware updates are available.
EOS R1 - Version 1.0.1
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R5 - Version 2.1.0
EOS R6 - Version 1.9.0
EOS R3 - Version 1.8.0
EOS R7 - Version 1.6.0
EOS R10 - Version 1.6.0
EOS R6 Mark II - Version 1.5.0
EOS R8 - Version 1.4.0
EOS R50 - Version 1.3.0
EOS R100 - Version 1.1.0
Powershot V10 - Version 1.3.0
07/01/2024: New firmware updates are available.
CR-N700 - Version 1.4.0
CR-N500 - Version 1.5.0
CR-N300 - Version 1.5.0
CR-N100 - Version 1.1.0
CR-X300 - Version 1.3.0
RC-IP1000 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
