Printer Software & Networking
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Canon MX870 to new Netgear R7900

Just installed a new Netgear X6 R7900 and attempting to connect my printers to the router. The HP works fine but the Canon Pixma MX870 shows as being connected (192.168.1.5) however the red light is on for the Port on the router and it will neither p...

Raydeo by Contributor
  • 2883 Views
  • 2 replies
  • 0 likes

Resolved! Set up MX450 for wireless access

I hope this doesn't get too complicated;I had a network set up with a Verizon DSL connect to a local home network.  I could never get the MX450 to be reognized , or connect to this network.I have since been upgraded to Verizon FIOS , have a new Fios ...

deshacn by Contributor
  • 9339 Views
  • 5 replies
  • 0 likes

MG2950 wireless connection

I have the Canon MG2950. I had connected wireless on my old router. But now I have a new router and I do not know what do I have to do in order to install again the wireless connection. Thank you in advance.

nicole1 by Apprentice
  • 2541 Views
  • 0 replies
  • 0 likes

Printer not connecting to phone

I have the Canon MG3520 and I tried connecting it to my phone and it won't connect to my phone at all. I tried adding the canon service app to see if it would work and nothing. What should I do? And how do I reset my printer?

Cannot setup wireless LAN on PIXMA MX922

I just bought the PIXMA MX922 and I can't complete the WLAN setup. Undert the Standard setup, when the printer searches for the wireless access point, I get the error message: "Access point was not detected." I then go into the LAN settings to check ...

Irvin432 by Apprentice
  • 3754 Views
  • 3 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements