01-31-2023 03:38 PM - edited 01-31-2023 03:51 PM
I recently purchased a Canon imageCLASS MF453dw multi-function printer and scanner. I've noticed that when scanning from the platen glass input source a several pixel wide white border is present in the scanned image, even though the object I'm scanning is all the way in the corner on the scanning bed. The attached scan of the user manual for the printer illustrates this. The white border can be seen at the top and left of the scanned image.
Can this border be disabled? Is my printer defective or is this how all of them scan? Thanks for everyone's help and input!
02-27-2023 05:52 PM
Hello Gtg362i,
The image above looks like the scanner was set to scan the full platen or is set to the wrong size. We can help with adjust the scan settings to resolve the issue. You can try adjusting the scan settings on the display or from your device using the scanning instructions in the link HERE. We would be happy to assist with the issue. To provide some feedback or some troubleshooting steps, we would need some additional information. If you could reply to this message with the information below, we can provide some assistance. You can also contact support over the phone at 1-800-652-2666. Our agents would be happy to help with adjusting the scanner settings.
03-01-2023 07:38 PM
I'm using Windows 10 and I'm scanning from the MF Scan Utility software
03-21-2023 01:14 PM
Hello Gtg362i,
When scanning from the MF scan utility, you can adjust the size of the paper size so the document is the only item that is scanned.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 1.1.0.0
PowerShot SX420 IS - Version 1.1.0.0
PowerShot 620 HS - Version 1.1.0.0
PowerShot SX720 HS - Version 1.1.0.0
PowerShot G1X Mark III - Version 1.1.0.0
PowerShot G7X Mark II - Version 1.2.0.0
PowerShot G9X Mark II - Version 1.1.0.0
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!
EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STMCanon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.