EOS DSLR & Mirrorless Cameras
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Feature Request-Low ISO or ND in-cam filter

As I was stacking ND filters on my camera this last week, I thought that it would be nice to enable very low ISOs, or at least an electronic ND filter. I'm not an engineer, but it seems possible to simply reduce the sensitivity of the chip resulting ...

jblooo by Contributor
  • 2942 Views
  • 1 replies
  • 0 likes

CF card not able to be read

I have a 5DM3 and have not had any issue with it until recently.I inserted a CF card that I have been using in the past in this camera, and went to format it and the camera told me it cannot be read or formatted. I tried another card, and got the sam...

Shooter by Apprentice
  • 3430 Views
  • 5 replies
  • 0 likes

Lens fit

I have a Canon EOS XTi Rebel. I'd like to know if a Canon EF 75-300 f/4-5.6 lens will fit it.Hope it will, my wife already won the bid for it on eBay!

koach51 by Apprentice
  • 2009 Views
  • 4 replies
  • 0 likes

Resolved! debris on viewfinder

Recently decided on the Canon T3i over the Nikon. Upon unboxing found what looks like a large spec of debris on the viewfinder.  Looks like the spec is inside the viewfinder glass.  Upon reading various posts about this Camera/issue, it looks like th...

mg007 by Apprentice
  • 5026 Views
  • 5 replies
  • 0 likes

5D3 Firmware 1.2.1 - TESTS & COMMENTS

Hi everybody, Now that Canon has officially released firmware 1.2.1 for EOS 5D Mark III, it would be GREAT to share experiences about the new performance. Especially regarding the clean HDMI 4:2:2 8bit output, since it's the most important and innova...

HDCamTeam by Enthusiast
  • 11669 Views
  • 18 replies
  • 1 likes

Resolved! Slow AF on 1DX with IR Assist

I have been using both the 5D3 and 1DX since they were released as an event shooter and have been suffering through the slow AF lock in low light with IR assist on BOTH cameras.  The recent firmware upgrade on the 5D3 worked like a charm and I am now...

very poor quality - 1Dx etc

I have been using Canon EOS products since year 2011, which covers from 60D to 1Dx, in year 2012, after 8000 shots, I sent my 5D Mark2 to Canon service center for repair because there were a few dead pixels,  after I got my 5D Mark2 back, I had anoth...

bu5ted by Contributor
  • 4348 Views
  • 12 replies
  • 0 likes

Resolved! Shutter Release Button

I just purchased the Rebel T31 with attachable 18-135mm lens and 55-250 lenses. I notice in autofocus that there are certain times when I need to hold the shutter button down a few seconds before it takes the picture. Is this normal, or should I be u...

Resolved! 60D-Aperture problem when shooting video

I have a 60D with an 18-135 mm 3.5 lens. I've set the camera for manual exposure. When I have the lens full wide, the aperture reads 3.5, when I zoom in tighter, the aperture changes to 4, 4.5, etc. Seems like there's something automatic going on tha...

Getting started

New to the community? Here's some information to help you get acquainted:

Announcements