12-09-2018 03:13 PM
I've been printing quite successfully with my TS9020 for quite some time but today things took a bad turn. I made sure I have plenty of ink in the printer and everything prints fine except for black. I printed a nozzle check and I've attached it. As you can see the first pattern is all messed up as if it's double printing. I've done cleaning and deep cleaning to no avail. Any suggestions?
12-14-2018 09:10 AM
Hi vbalbert,
I would recommend performing a print head alignemnt. Please click HERE for the steps to perform the alignment.
If the alignement does not resolve the issue, troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.