Professional Photo Printers
cancel
Showing results for 
Search instead for 
Did you mean: 

Posts

Resolved! Printing from Lightroom

I am trying to print 12 x 18 photo on 13 x 19 paper. Ligthroom does not allow me to go below .79 on the right border. In fact it shows a portion of the paper on the right as gray. Any suggestions?

gleuropa by New Contributor
  • 2445 Views
  • 5 replies
  • 0 likes

PIXMA PRO-10 INSTALLATION ISSUES FOR MAC

Hello guys, So I just received this printer yesterday and am having a lot of difficulty setting it up.  I have a Aple Macbook Air that doesn't have a CD rom drive built in.  I went on the cannon website to download the drivers/software: (https://www....

dom0wnz by New Contributor
  • 3676 Views
  • 3 replies
  • 0 likes

Pro 100 printer problem

I am trying to print 6*4 photos. Sometimes the photo paper which is not a Canon product, goes straight through without printing. Most of the time, there is a support 1300 paper jam. I don't have this problem with 8*10 photos.I hope someone can help.J...

joed by New Contributor
  • 3073 Views
  • 3 replies
  • 0 likes

Pro 9500 Mark II - profile for HR-101N paper

I can't figure ut which profile to use when printing to Canon HR101N paper from my Canon Pro 9500 Mark II printer. Surely it must be obvious given this is a Canon paper, but I can't find the profile. It doesn't seem to have been installed with the st...

loose_canon by Occasional Contributor
  • 2877 Views
  • 6 replies
  • 0 likes

lines through Pro 9000 Prints

sets pf parallel lines are in all of my prints. I use canon ink and paper. I changed all of the cartridges and ran all of the cleaning, deep cleaning and smudge programs. No Change.  Anyone know how to fix this?Thanks,Daniel

FDH76 by New Contributor
  • 2108 Views
  • 1 replies
  • 0 likes

Will not use 13 x 19 paper

I keep getting a "A paper size that cannot be fed from Rear Tray was selected." error, even though I have used this paper routinely in the past. Is there some setting I am missing to override this? Thanks

MikeAdams by Occasional Contributor
  • 3195 Views
  • 5 replies
  • 0 likes

Cannon Pro 100 not using all of the ink

Hi,I have a question about ink. I am using the Canon Pro-100. I am using Canon brand ink and the grey is not being used up, but says the tank is empty. It is only using about half. If I insert a new one, it works fine. This is now the 4 time it happe...

Canon Ink grey.JPG
jboremski by New Contributor
  • 1831 Views
  • 1 replies
  • 0 likes

Pixma pro-100 Printhead Clogged

So i just bought this Pixma pro-100 and have only printed a few prints and I started getting bad looking prints so I did a Cleaning and that did not fix it and I see lins in the Gray. So I tried Deep cleaning and still the same lines I have tried thi...

bwolcott by New Contributor
  • 4080 Views
  • 2 replies
  • 0 likes