10-14-2016 03:43 AM
Hi there,
Error B200 pops up when i turn on my printer, says I should contact service Center. Tried turning it on and off several times and unplugging for some time and plugging it back in to the current but nothing. At one point it did start normally at which point I changed one of the cartridges but then went back to error B200. When the printer turns on directly in error mode i can even get the ink drawer to open, so if it is a problem of the cartridge installation I am not sure what I can do to fix it.
Has anyone had this problem before and managed to solve it?
10-14-2016 06:32 AM
Give Canon a call at 1-800-OK-CANON and see if they have any ecomendations.
06-14-2021 04:41 PM
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.