TM-300 Plotter, Cut the last page to correct size after roll has run out?

[Chaos_Colourful]

It sometimes happens that when I get the notification that the roll of paper has run out, the drawing has actually finished printing but the page is has not been cut yet. So I have a fully printed drawing but a slightly oversized page.

Is there a way to get the printer to get the few extra inches off the end of the page, rather than me trying to cut the short side of an A0 drawing neatly?

[Sonya1]

Hi Chaos_Colourful,

Try disabling "Manage remaining roll amount" under Paper-related settings in the Device Settings on the printer's control panel. Once you have disabled Manager remaining roll amount, eject the media then restart the printer.  When the printer restarts, reload the roll.  If this doesn't resolve the problem, let us know.