07-24-2024
04:52 AM
- last edited on
07-24-2024
08:00 AM
by
James_C
It sometimes happens that when I get the notification that the roll of paper has run out, the drawing has actually finished printing but the page is has not been cut yet. So I have a fully printed drawing but a slightly oversized page.
Is there a way to get the printer to get the few extra inches off the end of the page, rather than me trying to cut the short side of an A0 drawing neatly?
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.