09-28-2017 02:21 PM
Hi,
I am new in the Canon world, today I replaced a main controller PCB, and after configuration of printer on win 7 64bit, and toolbox, everytime I choose to scan for pc option color (I get) a PDF with the image, neverless with bad quality as I supect the CCD is not ok, neverless if I choose B&W mode I get a blank pdf.
The copies from ADF and from flatbed are +-, less quality on ADF.
I already programmed the values of the service card.
I could not import the rest or do a export because the other board went down.
An help would be very appreciated.
Thanks in advance,
Joao.
Solved! Go to Solution.
10-18-2017 01:49 PM
Hi,
thank you but I already overcome the problem by myself.
regards,
John
10-11-2017 10:53 AM
Hi jnobre,
Based on the specfic issue described, It is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
10-18-2017 01:49 PM
Hi,
thank you but I already overcome the problem by myself.
regards,
John
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.