10-08-2023
11:54 PM
- last edited on
10-18-2023
10:02 AM
by
Danny
I just purchased a MF642Cdx.
After setting it up on a Windows 11 Home, it has weird scan properties.
When I scan something, whether from from the machine or from my PC using the MF Scan Utility, the progress indicator pops up but never advances past 0% and it stays there until I cancel the job.
What is strange is that if I cancel the job from the MF, the progress indicator quickly progresses to the end and prompts me for the next scan.
So, the scan completes, but only after I cancel it.
Not cool.
Any ideas anyone?
Thanks.
Solved! Go to Solution.
10-10-2023 05:45 PM
Issue resolved.
I just connected the MF642 to my PC with a USB cable and installed the USB drivers and now everything works.
10-10-2023 05:45 PM
Issue resolved.
I just connected the MF642 to my PC with a USB cable and installed the USB drivers and now everything works.
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.