Desktop Inkjet Printers
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

MG7720

I got a notice to update the firmware at Device Settins in Setup.  I started the update but then received an error msg that it couldn't be updated.  Now the screen is grey and the power light is blinking.  Nothing happens when I hit the power button,...

PIXMA 5450 SHRINKING DOCUMENT TO CORNER OF PAGE

 Yesterday I was trying to print out a document. The document shrank to the corner of an A4 sheet to what I would say is A6 size. It now keeps happening. I am using Macbook Air running OS X EL Capitan. I have done a bit of googling and have tried upd...

TINAMOO by Apprentice
  • 2984 Views
  • 1 replies
  • 0 likes

Pixma G2200 photo print

I just purchased. g2200. The reviews say it prints very good color photos. I tried printing ok (old) Kodak photo paper and the results were not all that good. The image was not sharp, and the colors seemed a little muddy. Is there something I can adj...

"Please wait a while" Message for scanning

I'm using a Pixma 490 and trying to scan images into my macbook. I am connected through the USB. When I try to scan an image Image Capture pops up like it should on my computer, but a message of "please wait a while" comes up on the printer. I wait, ...

Blue/cyan tints in black areas of b&w prints

I removed the print head and thoroughly flushed all ink following the instructions most often suggested until the water ran clear. Used distilled water only and was careful not to get anything wet that isn't supposed to get wet. Completely let the he...

brassman by Enthusiast
  • 4711 Views
  • 5 replies
  • 0 likes

issue on pixma g2400

First of all, Hello world!I just bought the pixma 2400 and some glossy paper from kodak 200 and 240 g/m*m. I installed the printer, all good until i printed on the glossy paper (on both 200 and 240 g/mm). The photos have some vertical dotted streaks,...

ulmane by Apprentice
  • 3329 Views
  • 2 replies
  • 0 likes

Canon Pixma MP280 set-up

I've just bought a new Canon Pixma MP280 printer.(I'm resident in Thailand)When I load the set-up disc it doesn't seem to matter which region/place of residence  I select I do not get a language optionafter the installation is complete everything loa...

MG2220

A week or so my Cannon MG2220, which has been very reliable, all of a sudded ate up about 3 sheets of paper.  After cleaning it out and starting again the print is out of align and I have a blank spot down the middle of every page.  Followed all onli...

ptanner by Apprentice
  • 2418 Views
  • 0 replies
  • 0 likes

printer

Received my Canon Pixma MX922. everything out and unwrapped. cut on siuaid ok to English...put color cartridges in. It continuously goes thru showing putting each color in. Won't go any further. please advise.

Getting started

New to the community? Here's some information to help you get acquainted:

Announcements