Trying to set up my new MX922. When I turn it on I get a message “Support code 5101. Remove the protective material if it is attached to the holder and turn off power and back on.” There is a diagram showing the top open and a bit at the side. I ...
I am trying to print business cards and I need to now the thickest card stock I can use for the Canon Pixma MX 430 series. I dont can not find the information online anywhere.
I purchased a new printer, MG2520, and i see a lot of people complaining about not getting a usb cable. I saw it on the box that it's not included. I assumed that meant it worked wirelessly without the cable. I was wrong. Luckily i found an old cable...
Printer keeps flashing four times in the alert zone, therefore indicating error 1687, incorrect installation of a FINE cartridge. However, everything checks out fine. A problem I noticed is that the cartridge carrier is not moving itself at all, and ...
My ip7220 is very slow and hesitant, it will print one pass and 30 sec. later it will print another, I am trying to print an 8 1/4" square image on plain paper, it then ejects the paper with only 2" of the image printed. It has been recommended that ...
I have an MX925 which has had light use since new in june 2016.It has begun erratically to not feed paper from the primary (lower) tray and giving error 1008 'out of paper' despite there being plenty of standard A4 paper.I have run the cleaning proce...
I am trying to print from my PC to my Canon Selphy CP1200. Sadly though, whenever I try, the Selphy shows the question mark error mentioned in other forum messages where it says "Cannot print incompatible images or memory card not readable". I have ...
Hello there. So I have a Canon Pixma 495 printer that worked great wirelessly for 5 months but all of a sudden my Macbook Pro stopped detecting it. I tried reinstalling the Canon drivers but the installation will not complete on account of the printe...
Okay ... Auction sites have these different type of trays for e.g. Canon Printers ? Is it possible to print onto CDs / DVDs on my MG3650 ; ... Suitable Discs provided !!! What type of tray would it be ? I see there are some tray type Js and so on . T...
3 colour inks were new last week so I know that the status is oorrect. Tried removing and replacing the inks but still have the red lights.
I have a new G4210, and when I print photos, they come out much warmer than they should. I am using using a custom color profile through Photoshop and everything looks good until I click print preview as the print preview image is different than the...
Are there any color profiles for the G4210 (using Red River paper). I see lots of Red River profiles, but none for my specific printer. Thanks.
hi,ive had my canon pixma mg6450 for a couple of years now and everything has been fine until recently. when i printed a letter ,the print came out like it was ghosting,trying to read it was like looking at text when you drunk.if you change the colou...
My Canon MX922 has been working very well for the past several years, yet recently it started rebooting by itself. I think it hangs and then ends up restarting. Here's how I find it most of the time. I did a full reset and left it alone for a few da...
