08-26-2024 04:20 PM - last edited on 08-27-2024 10:29 AM by Danny
Bumped the output supporter on an MG7720 inkjet printer. Now it seems to be disconnected from its operating mechanism. Repair options?
07/01/2024: New firmware updates are available.
CR-N700 - Version 1.4.0
CR-N500 - Version 1.5.0
CR-N300 - Version 1.5.0
CR-N100 - Version 1.1.0
CR-X300 - Version 1.3.0
RC-IP1000 - Version 1.1.0
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
EOS R7 - Version 1.5.0
EOS R8 - Version 1.3.0
EOS R10 - Version 1.5.0
EOS R50 - Version 1.2.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS R3 - Version 1.7.1
EOS R5 - Version 2.0.0
EOS R6 - Version 1.8.4
EOS 1DX Mark III - Version 1.9.0
WFT-R10 - Version 1.3.1
