Canon Community

williamauer · 12-06-2015

I only have two computers set up to use this printer. Each one reports that another computer is using the printer and so cannot print. So the printer is just a brick right now. I've cycled the power on it several times with no change in status. I fin...

williamauer · 11-29-2014

The printer seems to do this to me about once a month. If I pull the plug and then reconnect it, that resets everything and gets the printer going again, but I get a nasty error message that I'm not supposed to do that. But what else can I do when ab...

williamauer · 05-27-2014

I had some problems and had to reinstall my MX922 on my Windows 7 Pro (64-bit) computer. I used an Ethernet cable during installation but then switched over to wireless. But Canon IJ Scanner Selector is still showing the MAC address for the wired LAN...

williamauer · 10-23-2013

I've just installed the newest drivers, dated 10/1/2013, for my Pixma MX922. My desktop computer is running Windows 7 Pro, 32-bit and the Pixma is connected via wired Ethernet. Using the old drivers I was able to scan documents in 20-30 seconds per p...

williamauer · 01-06-2016

I had no end of problems with this same thing. I think I may have found the answer, it has certainly worked for me. I only have two computers on my network that share the printer, but I found out that both computers were trying to access the printer ...

williamauer · 12-06-2015

8.5x11 and 8.5x14 pages should both scan OK using the ADF simplex setting. Open the Canon IJ Scan Utility and click on the Settings button in the lower right corner.On the next screen, click on Document Scan, then pull down the Select Source settings...

williamauer · 01-05-2015

Mine seems to be behaving fairly well since I went into my router settings and assigned a fixed IP address to the printer. My theory is that every time the IP address expired and the router assigned a new IP address to the printer, that's when the pr...

williamauer · 06-05-2014

The solution above did not work for me. I still have the problem.

williamauer · 05-27-2014

I figured it out. I reinstalled the MP drivers (again!) and that fixed it. IJ Scanner Selector now has both wired and wireless MAC addresses for the scanner so all I have to do is to make sure I select the correct one.

Canon Community

User Statistics

User Activity

Pixma MX922 won't print, both my computers show status is "another computer is using the printer".

MX922 hangs, power switch won't turn it off. Can I get it going without just pulling the plug?

MX922 Prints but can't scan

Slow Scanning with Newest Driver for Pixma MX922

Re: MX922 keeps going offline

Re: Canon PIXMA MX922 whole page not scanned

Re: MX922 keeps going offline

Re: MX922 keeps going offline

Re: MX922 Prints but can't scan