10-27-2013 07:02 PM
10-29-2013 12:57 PM
This seems odd. Normally my units "remember" if they were in a master or slave even between usage (e.g. if a unit was last used as a slave, powered off and put away... when I power up the flash (even a few days later) the flash "remembers" that it was last used as a slave and resumes that way.)
I had considered maybe a loose wire... so I set a unit as a radio slave, powered off and opened the battery door (just in case removing batteries causes a 'reset'), closed the door and powered it back on and it STILL remembered it's a slave.
I'd contact Canon. I can't think of a reason or condition that would cause a slave to reset spontaneously unless it's a defect.
10-30-2013 10:19 AM
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.