03-20-2016 09:59 AM
Hello!
I just setup the Pixma Pro 100 and the first 4 photos I printed look terrible. On my MacBook Pro they look great, but when the print job is complete the photo have a very blurry / wet look.
Any suggestions? I've tried printing from Preview, Photos (iOS software), and CS Photoshop.
03-20-2016 10:39 AM
03-20-2016 10:43 AM
Thanks I'll try that.
Another thing I noticed is that all of the product demos on YouTube it took several minutes for the print to finish. Mine printied in a few seconds.
03-20-2016 11:00 AM
03-20-2016 11:42 AM
03-20-2016 11:54 PM
Another question.
My photos print fine on 8.5x11 paper. But when I put in my A3 paper it won't print.
The print loads the paper fine, but then I get an error and the job never finishes. Any advice??
03-21-2016 01:11 AM
Is there an error number or message, or just error?
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.