03-20-2016 09:59 AM
I just setup the Pixma Pro 100 and the first 4 photos I printed look terrible. On my MacBook Pro they look great, but when the print job is complete the photo have a very blurry / wet look.
Any suggestions? I've tried printing from Preview, Photos (iOS software), and CS Photoshop.
03-20-2016 10:39 AM
03-20-2016 10:43 AM
Thanks I'll try that.
Another thing I noticed is that all of the product demos on YouTube it took several minutes for the print to finish. Mine printied in a few seconds.
03-20-2016 11:00 AM
03-20-2016 11:42 AM
03-20-2016 11:54 PM
My photos print fine on 8.5x11 paper. But when I put in my A3 paper it won't print.
The print loads the paper fine, but then I get an error and the job never finishes. Any advice??
03-21-2016 01:11 AM
Is there an error number or message, or just error?
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 18.104.22.168
PowerShot SX420 IS - Version 22.214.171.124
PowerShot 620 HS - Version 126.96.36.199
PowerShot SX720 HS - Version 188.8.131.52
PowerShot G1X Mark III - Version 184.108.40.206
PowerShot G7X Mark II - Version 220.127.116.11
PowerShot G9X Mark II - Version 18.104.22.168
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.