MG2922 Connected but wont print

[rjthom15]

My MG2922 is connected to my router via WiFi, however it will not print. 

I held the stop button until the alarm light flashed 15 times to get the configuration page and the important stuff reads as follows:

Wireless LAN        Enable

Connection            Active

SSID                      "my wireless signal name"

Comm Mode          Infrastructure

Channel                  10

Encryption              AES

WEP Key                WPA2-PSK

Signal Strength       100%

The printer obviously shows its connected to my internet but will not print anything.

[BillS]

Hi rjthom15,

Let's also re-install the printer driver.

1. Click HERE.

2. Scroll down to "Optional Drivers."

3. Click “Select” next to "MG2900 series MP Drivers."

4. Press "Download."

5. Open and run the file.

6. Follow the onscreen instructions to complete the installation.

This didn't answer your question or issue? Please call or email us at one of the methods on the Contact Us page for further assistance.

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.