11-11-2012 04:36 PM
Canon MX860 has error code B200, have cleaned and removed printer head
code still blinks.
11-02-2016 12:40 PM
The easiest way to fix this error is to open the printer as if you were going to change ink, wait for the cartridges to move past the half way point around 3/4 across and simply shut the lid. This works every time for me, although it may take a few tries. After you complete this simple technique, a person will then have control of the printer and can do whatever type of maintenance they would like-it gives you your printer back
11-07-2016 06:15 PM
Many thanks for this solution - worked a treat.
12-25-2016 09:35 AM
I tried a few times turning off and on after pushing the ink to the right as mentioned, but what finally worked was opening the hood to watch the ink when turning on again (leaving it open until it was done). THEN I heard the scan/copy reset itself and the ink went through its normal back and forth warm up.
Seemed to be fixed, but then when I closed the hood to copy - the whole machine died. ARGG! Looks like it´s finished.
02-11-2017 12:11 PM
Thank you batteryheadbill!
I had to try his directions multiple times. I even wiped off the main print head (that all the print cartridges go into) and installed new print cartridges for the two that were low (they flash red when low). But then, it worked! Yay! Thanks again. We were worried we would have to buy a new printer before we could get this one to work and of course, right before taxes are due and we needed it to work.
So relieved that something finally worked!
02-26-2017 01:03 PM
batteryhead you are a godsend!!!
04-23-2017 06:56 PM
Code B200 solved I found a new (QY6-0083 Printhead) on eBay for $15.00 and installed it, Walah!! No more Code B200 and that’s the name of that toon it prints perfectly, Print Head For Canon MG7120
05-03-2017 08:15 PM
06-23-2017 11:02 AM
Hey, just shoving the printer cartridge with all my might did my heart good! The old B200 fix that's worked for me for a long time was opening the printer cartridge, letting it go past halfway, then immediately closing all. This time it didn't work, but your solution has, at least in the short term, stopped the damned B200!
02-09-2018 01:58 PM
regarding the steps to open the printer and remove the printer heads....the printer head tray will not move over.
What should I do next?
thanks,
Brian – London, Canada
09-13-2018 08:29 AM
I was truly amazed that what you said to do , WORKED! It is a miracle!
03/18/2025: New firmware updates are available.
EOS R5 Mark II - Version 1.0.3
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.