EOS DSLR & Mirrorless Cameras
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Posts

Canon EOS R6 Totally Dead?

I have had a Canon EOS R6 since January 2021, and it hasn't been used that much since I bought it. Inexplicably, now it will not turn on. I have tried different batteries, tried a dummy battery. No signs of life happen. I've looked into the battery c...

nflorida by Apprentice
  • 1453 Views
  • 2 replies
  • 0 likes

eos m50 not recognizing lens unlock

Hello, when I turn on my camera and follow the prompt to unlock, the lens unlocks correctly (as in I can push the button and turn the lens to unlock) but the prompt does not go away when I do this and I cannot take a picture.  Any ideas.  Battery ful...

EOS Rebel T3i Err 05

I have a Canon EOS Rebel T3i. When on manual mode, my built-in flash pops up, but the display says "err 05 The built-in flash could not be raised. Turn the camera off and on again." But the built in flash IS raised. So even though the built-in flash ...

jodihlee by Apprentice
  • 1204 Views
  • 4 replies
  • 0 likes

Resolved! canon rebel t7 autofocus

When I point the camera at the sky to take photos of the sunrises etc...it zooms in and out but won't let me take the photo...also there is a big dot on the lower right corner..it works when I'm not pointing towards the bright light

tzegray by Contributor
  • 11120 Views
  • 8 replies
  • 0 likes

Canon 5D iv - rate button is NOT in exif.....

I am researching why I cannot find "RATE" button data on Canon 5D iv in EXIF data.When I press the "RATE" button on the back of the camera it will record the data on the CF when 2 cards loaded. BUT, when I use an EXIF extractor program the data canno...

Bartee by Apprentice
  • 707 Views
  • 2 replies
  • 0 likes

EOS Rebel SL2 Firmware Won't Update

So I just updated my camera to the 1.0.3 firmware and then saw there was a new firmware for 1.1.0 But now my camera won't let me add any new firmware. It works just fine, it connects to my computer like always. But when I try to do a firmware update ...

aiamkay by Apprentice
  • 671 Views
  • 2 replies
  • 0 likes
Getting started

New to the community? Here's some information to help you get acquainted:

Announcements