03-04-2015 07:46 PM
I started taking a photography class this past January. Unfortunately my professor teaches everything with Nikon and doesn't know very much about Canon. I bought my Canon this January and have been learning all the ins and outs. However, when I try to take a picture in the dark (part of my assignment), regardless of the setting, the camera will not snap. I have to turn on some lit before it would work. The professor took several shots with his Nikon in class with the lens cap on to demonstrate in class. Do any of you know why?
03-04-2015 09:34 PM
03-04-2015 11:59 PM
Thanks a whole lot. It worked.
03-05-2015 01:03 AM
In "One Shot" mode (the default), the camera uses "focus priority". It will not snap a picture until it can confirm focus lock. It WILL take the shot if you switch off auto-focus (because now you've basically told the camera not to worry about focus.)
In "AI Servo" mode, it uses "release priority". It will take a picture as soon as you fully press the shutter button and it will do this whether or not it was focused.
When shooting in the dark you would presumably be using flash OR a tripod.
03-05-2015 06:10 AM
03-05-2015 10:26 AM - edited 03-05-2015 10:26 AM
"Unfortunately my professor teaches everything with Nikon and doesn't know very much ..."
I agree with this part! I have a Nikon D3 in my hands right now and I garrantee you it will not take a picture with the lens cap on and the lens in AF. It is no differen than your D70 in that reguard.
03-05-2015 07:16 PM
Thanks to you all for your responses. I am sure as I go along with my class and learn more about the camera, I will have more questions. Thnaks
03-07-2015 11:12 AM
03-09-2015 04:52 PM
Another solution use a flashlight to illuminate your subject for focus..
03-09-2015 05:18 PM
@scottmurray wrote:Another solution use a flashlight to illuminate your subject for focus..
OK, if you've actually tried it. But I believe that AF assist beams tend to be biased towards the red end of the spectrum, while modern flashlights try to radiate at frequencies that are a better match for the sensitivity of the human eye. So you may need to use a flashlight that's bright enough for that not to matter.
Also, it's easier to use a flashlight as an assist beam if you happen to have three hands.
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.