11-01-2018 10:53 PM
In SCN or CA mode after I set the desired parameters can I lock them so when I switch modes then come back the parameters will still be where I set them?
Solved! Go to Solution.
11-02-2018 12:42 AM
Hello timb12957,
The SCN and CA modes do not lock in the settings in the case you were to switch modes.
11-05-2018 08:57 PM
Hi denmarks!
Thanks for posting in the Canon Forums!
If you want to create a new thread, all you need to do is go to the board you want to post on and you should see a Post Message button. Once you're on the Post Message page, you will see a Subject area and a Body area. From there you can compose your post and hit Submit Post to post it to the board for everyone to see. These instructions may vary based on if you're visiting the Canon Forums from a computer or a mobile device. We recommend using a computer for the best results.
We hope this helps!
11-05-2018 09:08 PM
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.