cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

D70 Can I Lock the SCN and CA settings?

timb12957
Apprentice

In SCN or CA mode after I set the desired parameters can I lock them so when I switch modes then come back the parameters will still be where I set them?

1 ACCEPTED SOLUTION

Tim
Authority

Hello timb12957, 

The SCN and CA modes do not lock in the settings in the case you were to switch modes.  

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.

View solution in original post

11 REPLIES 11

Hi denmarks! 

Thanks for posting in the Canon Forums! 

If you want to create a new thread, all you need to do is go to the board you want to post on and you should see a Post Message button. Once you're on the Post Message page, you will see a Subject area and a Body area. From there you can compose your post and hit Submit Post to post it to the board for everyone to see. These instructions may vary based on if you're visiting the Canon Forums from a computer or a mobile device. We recommend using a computer for the best results. 

We hope this helps! 

Thanks,
I don't get the Post Message button but I do get a New message button, which looks like it will work. I do use a computer with Chrome. Maybe Explorer works better...
Announcements
01/18/2023: New firmware version 1.1.1 is available for EOS R6 Mark II
01/09/2023: Help ensure your autofocus is properly aligned with a Canon Precision Alignment
01/03/2023: Welcome to CES 2023!
12/08/2022: New firmware version 1.0.5.1 is available for EOS C70
12/07/2022: New firmware version 1.7.0 is available for EOS R5
12/07/2022: New firmware version 1.7.0 is available for EOS R6
11/22/2022: New firmware available for EOS R3, EOS R7 and EOS R10
11/16/2022: We're thrilled to be ranked among the Best Employers for Veterans in 2022 by Forbes.
08/31/2022: New firmware version 1.1.1 is available for RF 70-200mm L IS USM
08/09/2022: New firmware version 1.2.0 is available for CR-N 300
08/09/2022: New firmware version 1.2.0 is available for CR-N 500
07/14/2022: New firmware version 1.0.1 is available for CR-X300
06/10/2022: Service Notice:UPDATE: Canon Inkjet Printer continuous reboot loop or powering down
06/07/2022: New firmware version 1.3.2 is available for PowerShot G7 X Mark III
05/31/2022: Did someone SAY Badges?
05/26/2022: New firmware version 1.0.5.1 is available for EOS-C500 Mark II
05/26/2022: New firmware version 1.0.3.1 is available for EOS-C300 Mark III
05/10/2022: Keep your Canon gear in optimal condition with a Canon Maintenance Service
05/05/2022: We are excited to announce that we have refreshed the ranking scale within the community!
04/26/2022: New firmware version 1.0.1.1 is available for EOS R5 C
03/23/2022: New firmware version 1.0.3.1 is available for EOS-C70
02/09/2022: Share Your Photos is back!
02/07/2022: New firmware version 1.6.1 is available for EOS-1DX Mark III
01/19/2022: READY FOR ANYTHING EOS-R5 C
01/13/2022: Community Update. We will be retiring the legacy profile avatars on 01/20/2022. Click this link to read more.