12-19-2021 09:14 PM
I have a Canon Pixma TS6320 and I'm trying to print stickers on A4 holographic paper using the silhouette program. I've done it before with the near same exact design with the same exact paper and had no issues expect for a few pauses here and there as the ink dried. Now it gets to a certain beginning point, pauses and never moves again. If I don't interfere it eventually sends an error to whatever computer I'm using (I've tried two different ones to eliminate the computer as the problem) then spits the paper out if I leave it long enough.
I'm so confused and frustrated because I've never experienced this issue before, does anyone have any ideas or recommendations? I feel like I've tried everything at this point.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 188.8.131.52
PowerShot SX420 IS - Version 184.108.40.206
PowerShot 620 HS - Version 220.127.116.11
PowerShot SX720 HS - Version 18.104.22.168
PowerShot G1X Mark III - Version 22.214.171.124
PowerShot G7X Mark II - Version 126.96.36.199
PowerShot G9X Mark II - Version 188.8.131.52
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.