My Pixma mx882 door does not close

[bennyb1]

Door where printout comes out stays open.

Tried to close it, re-powered, remove the papar tray: still stays poen

[Michael]

Hello.

Turn the printer off.  Then check to see if there are any visible obstruction in the path that are keeping the door from closing properly.

If the issue persists, troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.

This didn't answer your question or issue? Find more help at Contact Us.

[bennyb1]

Clearing the path did not fix the issue. Support suggested to take if for repair, which would cost more than a replacement printer.