01-25-2016 11:49 PM
MY MG5170 has B200 error. I have tried many things on the internet including the replaced printhead(2-->1). it is an old printhead(1) that yellow cloged up and I replaced with the other one(2). and 3days pass it comes back on again. I have bought a new printhead but refuse to get it on because I thing the logic board is gone. Any suggestion without going to service center? Trash this and buy a new one? or Just point out the thing that could gone wrong at this state? Thank you in advance.
02/20/2025: New firmware updates are available.
RF70-200mm F2.8 L IS USM Z - Version 1.0.6
RF24-105mm F2.8 L IS USM Z - Version 1.0.9
RF100-300mm F2.8 L IS USM - Version 1.0.8
RF50mm F1.4 L VCM - Version 1.0.2
RF24mm F1.4 L VCM - Version 1.0.3
01/27/2025: New firmware updates are available.
12/18/2024: New firmware updates are available.
EOS C300 Mark III - Version 1..0.9.1
EOS C500 Mark II - Version 1.1.3.1
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.