Nozzles are clean. Nozzle check pattern is good. I cleaned the Timing strip. After performing either automatic or manual head alignment, the head alignment values come out the same. All values are within the given parameter value ranges (e.g., -5 to +5) except for three. "C" and "D" are at +5 and "F" is at -5 and none of the three are close to the correct patterns (i.e., they apparently need adjustment beyond the parameter value renges given.) When I print anything (especially with horizontal lines) the print is horizontally offset in several places on the page. Is there any way to correct this, for example, maybe by physically changing the position or orientation of somehting in the printer?
