06-03-2022 04:34 PM
I have an MG6650 and until a few days back it worked perfectly. Then it would not stay on. I had followed the reset a number of times but it made no difference. Having read the advice from
" MX490 power cycling fix from user on forum SPREAD THE WORD!"
I disconnected my router and the printer worked just as before on local wifi. I reset the DNS address to end on a higher number and I can print as before however printer now is disconnected from the internet.
Having read all the recent posts of similar problems what does it take for a permanent solution to come from the manfacturer?
Solved! Go to Solution.
06-07-2022 03:46 PM
Hi!
Canon released a firmware update to take care of this issue. Learn more now by clicking HERE.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
06-07-2022 03:46 PM
Hi!
Canon released a firmware update to take care of this issue. Learn more now by clicking HERE.
Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
06-09-2022 02:41 PM
Printer functions now just as before. Many thanks for the direction
09/26/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.1
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.